Our CAT6 standard boot patch cables offer the reliability of pure copper leads (no copper coated aluminum or CCA) and the durability of CM jackets and boots. With demands on network performance, each segment and part must perform with precision and accuracy. Individually bagged and labeled in retail packaging, these Cat6 cables are easy to store and the length and type is easily identifiable. Built to last, our high quality Ethernet cables are pure copper for maximum throughput and reliability. These snagless Category 6 (Cat6) patch cords have skinnier cable boots to make it easier to connect and disconnect the cable, as well as to prevent the cable from catching when pulled through tight spaces. We just saved you a ton of time and made managing your network cabling a whole lot easier! Introducing our EASYboot ethernet patch cables. Slip the boot off the hoof.2 ft Blue | CAT6 Ethernet Patch Cables | Easyboot (Ferrari-style) Loosen the worm clamp using the EasyKey by turning it counter-clockwise (see illustration). The tighter the fit, the better the boot will perform. Pull the top of the gaiter tight around the pastern. The worm clamp system is designed so that a flathead screwdriver or even a penny can be used to tighten or loosen the worm clamp if the EasyKey is misplaced. If all portions of the boot (excluding the gaiter) are below the hairline, tighten the worm clamp with the EasyKey by turning it clockwise (see illustration). Make sure all portions of the boot are below the hairline. Check for proper fit before tightening worm clamp. If you are having trouble please refer to the fitting video found at. Don’t use the gaiter to pull the boot on. You can also put the foot down on the ground and allow the horse to put weight into it. Using technique rather than strength, place the boot over the horse’s toe and, using a slight back and forth twisting motion, slide the boot on the rest of the way. Pick up the horse’s leg and support the cannon bone between your knees so that you can use two hands when applying the boot. Fold the gaiter back before fitting the boot over the hoof. Loosen the Easyboot Edge worm clamp using the EasyKey by turning it counter-clockwise (see illustration).

Easyboot edge test